Sulfur acid industry self-cleaning air filter

Sulfur acid industry self-cleaning air filter

  • SUMMARY: After the self-cleaning air filter inhales the air containing dust, it will cause the wear of the equipment, and the inhaled dust will scale on the surface of the fan blade, resulting in the dynamic balance imbalance of the rotor in the equipment....

Hot Product
Product Details

Filter medium: air

material: Carbon steel

Working pressure :0.4-0.6mpa

Operating temperature: room temperature

Form/knot: Vertical

Filtration accuracy: 1 micron

Application: air compressor front, blast furnace blower, gas turbine, diesel engine

Product introductions:

Sulfur acid industry self-cleaning air filter is controlled by intelligent distributor, self-cleaning methods are three, namely timing, pressure difference, manual.

The self-cleaning air filter can realize the automatic cleaning of the air filter element, so that the equipment can operate as usual, without affecting the normal work of other filter elements. Chemical fiber textile industry air conditioning air supply front self-cleaning air filter has large filtering area, low flow rate, small resistance loss, and liquid crystal display resistance loss. Long service life of filter element. Under general environmental conditions, the replacement cycle of the filter element can reach about ⒉ years. High degree of automation, the main components of imported parts, can achieve unmanned operation. The air consumption is small, generally 0.1 ~ 0.3m3/min(inhalation state); The pressure is 0.4 ~ 0.6Mpa. The weight of the equipment is light, and it is 1/3-1/2 of the same capacity of the cloth bag. Reasonable design, no bending design, high-rise block type combined type, easy to install, fast. This product has special requirements, the company can carry out non-standard design according to customer requirements to meet customer needs.

Performance characteristics:

Self-cleaning air filter The air inlet filter is equipped with protective steel mesh, secondary fiber filter cotton and filter cartridge. Most of the coarse and medium dust particles in the air flow precipitate to the dust collector drawer under the action of gravity and inertia, the fine dust is attached to the surface of the filter cartridge, and the clean air passes through the clean room in parallel and enters the power equipment. After the dust-containing waste gas enters the inlet of the dust collector, due to the sudden expansion of the air flow section and the action of the air flow distribution plate, the wind speed drops sharply, and some coarse particles in the air flow collide with each other under the action of wind power and inertia force, and naturally settle to the bottom ash hopper. The particle size and small density dust particles are deposited on the outer surface of the filter cartridge and intercepted through the combined effect of diffusion and screening, and the clean gas penetrates the inner wall of the filter material and enters the clean room and is extracted by the exhaust pipe through the fan. The resistance of filter element increases with the increase of the thickness of dust accumulation layer on the surface of filter material. The injection control mode can be divided into pressure difference control, time sequence control and manual control.


Technical parameter:

Model :LFZK-9600 

Filter medium :HV fiber filter cylinder 

Air volume :576000m 3/h

 Filter area :9600m2

Number of cartridges :480

Blowback pressure :0.4-0.6mpa 

cleaning method: pulse cleaning

Application: air compressor pre-filtration

Control mode: time control, pressure difference control, manual control

More product recommendations:

Self-cleaning air filter for coking plant

Outdoor self-cleaning air filter 

Related Products